Bass Rackhead E1060

The Rackhead 1060 is a full versatile bass amplifier to be used on tour or in a studio. It includes two independent bass amplifiers in one rack for flexibility. A tube preamplifier and a solid-state preamplifier are combined with two class D power amplifiers. Using one bass guitar with two fully different sounds. The two channels can be swapped by pressing only one switch so that there is no need for an external A/B switch or re-plugging to have full access to both sounds. These two channels can also be used from two bass players to play together over only one amp. Additionally, both power amplifiers of the Rackhead 1060 can be combined and fed into one or more cabinets to fill the need for higher sound levels on stage without losing the features of the two independent channels in the preamp stage.

Features:

-2 Channels (Tube and Solid-State Preamp)

-2 x 350 Watts or 1x 1700 Watts (2 Class D poweramplifiers)

-Switch Mode Power Supply (Wide Input for worldwide use)

-Mute switch for both channels Channels

 

All tube channel (A):

-2 Tubes 12AX7 – -12cB Pad

-Bright Switch -Gain Control -Clipping LED

-Drive Control and ON/OFF Switch

-5-Band Tone Control (Bass, Low-Mid, High-Mid, Treble, Presence)

-Bass Boost Switch

-Ultra Bright Switch

-Volume Control

 

Solid State Channel (B):

– -12dB Pad -Gain Control

-Clipping LED

-Shape Control and ON/OFF Switch

-4-Band EQ (Bass, Semi-Parametric Low-Mid and High Mid, Treble)

-Equalizer ON/OFF Switch

-Compressor ON/OFF Switch

-Volume Control

 

Both Channels:

-Master Volume

-Effect Switches (A/B ON/OFF)

-Protect LED for Poweramp Effects

– Effect Send and Return Jacks

-One effect can be assigned to one channel

– FX-Blend control on back panel Special

-Slave Output for Both Channels

-External Input for Both Channels

-Bi-Amping Output with adjustable crossover frequency

-Tuner Out (Symmetrically)

-DI-Out Pre-/Post-Preamp Switchable with Volume Control

-Ground Lift

–Speakon Outputs for Channel A and B

-Speakon Output for bridged Output

– Footswitch Input (supports ENGL Z-3, Z-4 or Z-9 Footswitches)

 

Dimensions:

Height: 3.5″ in (89mm) Width: 19″ in (483mm) Depth: 13 1/3″ in (337mm)

 

Sensitivity:

0 dBm Preamp output with 10mV 1kHz Input, Gain and Volume at Maximum, All tone controls flat (center position) and drive, Bass Boost, Ultra Bright, Shape , Equalizer, Compressor OFF; Effects Blend at Dry

 

Download: PDF Manual

 

TOP